9A418 Wireless Foot Control Accessory association Procedure Test and Repair
The wireless controller will only function after it has been associated with a single chair. This prevents unwanted movement in locations having more than one chair. Each wireless controller’s association is preset at the factory. This procedure is only required in the event of a malfunction, if a new controller is purchased, or if you are attempting to use the controller with a chair other than the one it originally came with.
1.On the wired foot control, press and hold the Stop and QuickChair buttons simultaneously. After two seconds, you will hear a single beep.
Step 2 must be performed within 3 seconds of Step 1.
2.On the wireless foot control, press and hold the Stop and QuickChair buttons until you hear three beeps. One long beep indicates the association failed. Unplug the unit for one minute and repeat Steps 1 and 2.
3.Check for proper operation of wireless foot control.
