Procenter Systems Delivery Unit, Lares® Handpiece Tubing Removal / Installation Test and Repair
Removal of Existing Handpiece Tubing
Procenter Systems Delivery Unit, Removal of Existing Handpiece Tubing
1.Disconnect three handpiece tubes (1) from kink valve (2).
2.Disconnect 1/8” green tube (3) from kink valve (2).
3.Disconnect two pieces of 1/8” green tubing (4) from 1/8” green tube (3); then insert straight barb fitting (5).
4.Disconnect two pieces of 1/8” clear tubing (6) from 1/8” clear tube (7); then insert straight barb fitting (8).
If removing 3-port tubing, the following Removal step is not necessary. Go to Installation procedure.
5.Disconnect handpiece tube (9) from 1/4” clear exhaust tube (10).
Installation of Lares® Handpiece Tubing
Procenter Systems Delivery Unit, Installation of Lares® Handpiece Tubing
1.Route Lares tubing (1) up thru hole in delivery unit; then connect 1/4” clear tube (2) to kink valve (3) as shown.
2.Install uni-clamp (4) onto 1/8” blue tube (5) and connect to kink valve (3) as shown.
3.Install a 1/8” to 1/4” barb fitting (6) into 1/8” clear tube (7); then connect to 1/4” clear exhaust tube (8).
