255 Light Replace the LED Light Module Test and Repair
Always disconnect power cord and allow time for light to cool before replacing. Do not touch the cone section of the LED light or reflector in light housing.
•Carefully handle parts near membranes and wire harnesses.
•Allow the light to cool before removing.
•Do not touch any non-black colored part of the LED light module.
•Carefully move the light away from the exam site to prevent contaminants from falling into the area.
Use only factory replacement lights, Refer to: parts list for order number.
1.Turn light off.
2.Turn off facility power breaker so there is no power in customer supplied wiring.
3.Remove screws and screw caps from reflector.
4.Separate front ring and faceplate from reflector.
5.Disconnect LED light module connector from LED light module.
6.Remove screws from LED light module.
7.Peel film paper off new LED light module then install into previous place holding LED light module with a clean cloth.
8.Complete steps 2 through 6 in reverse order.
9.Connect power and verify operation.
