255 Light Mobile Cross Tube Removal / Installation Test and Repair
Equipment Alert
Align three screw holes on the vertical tube with holes in ball pivot housing of the counterbalance assembly before installing any screws. Failure to comply may result in damage to screws.
1.Align three screw holes, then insert cross tube into vertical tube.
2.Install two screws into the holes at the top of the vertical tube.
3.Pull two wires from cross tube through bottom access hole.
4.Connect wires from cross tube to corresponding wires from vertical tube, then push wires into tube.
5. Slide sleeve into position, then secure with screw.
