354 Light Ceiling Mounted Main Pivot Stop Replacement Test and Repair

354 Light Ceiling Mounted Main Pivot Stop Replacement

1.Remove cross tube. Cross Tube Removal / Installation.

2.Remove down tube. Down Tube Removal / Installation.

Equipment Alert

Strain relief knot must be above the groove pin. Be sure that groove pin is between two wires, and that wires do not get pinched when pin is installed.

3.Remove main pivot stop.

a.Using a punch, remove groove pin.

b.Remove washer, pivot housing, and pivot stop.

c.Inspect two stop pins. Replace pin(s) if damaged.

d.Install main pivot stop, pivot housing, and washer onto shaft.

e.Install groove pin.

4.Install down tube. Down Tube Removal / Installation.

5.Install cross tube / lighthead. Cross Tube Removal / Installation.