355 Light Main Pivot Stop Test and Repair
To Replace Main Pivot Stop
1.Remove Cross Tube Refer to: Cross Tube Removal / Installation
2.Remove Down Tube Refer to: Down Tube Removal / Installation
Strain relief knot must be above the groove pin. Be sure that groove pin is between two wires and that wires do not get pinched when pin is installed.
3.Use a punch and remove groove pin.
4.Remove washer, pivot housing, and pivot stop.
5.Inspect two stop pins. Replace pin(s) if damaged.
6.Install main pivot stop, pivot housing, and washer onto shaft.
7.Install groove pin.
8.Install Down Tube Refer to: Down Tube Removal / Installation
9.Install Cross Tube / Lighthead Refer to: Cross Tube Removal / Installation
