625 Table Shrouds Access Procedures

625 Table Remove Shrouds 625 Table Remove Shrouds

Remove all accessories (chair arms, etc.) before performing this procedure.

1.Remove Cladding. Refer to: Cladding Access Procedures.

2.Push LH side lever up and RH side lever down. Remove drawer.

Side levers are clear plastic.

625 Table Remove Shrouds

3.Lower table to lowest height. Disconnect table power cord.

4.Remove screws from head-end and foot-end of outer shrouds.

5.Remove side screws and outer shroud. Repeat for other side.

625 Table Remove Shrouds

6.Remove two screws securing each set of shrouds. Repeat at head-end of table.

7.Remove six screws securing bottom of inner shroud.

1.Install six screws securing bottom of inner shroud.

2.Install four screws securing each set of shrouds.

3.Install side screws and outer shrouds.

4.Install screws at head-end and foot-end of outer shrouds.

5.Install drawer.

6.Install cladding.