630 Chair Base Shrouds / Cladding Access Procedures

WARNING

Always disconnect chair from power source before removing any covers. Failure to do so may result in personal injury.

630 Chair Raising Base Shrouds / Cladding w/ bungee cord

1.Remove two screws from inner shrouds.

2.Stretch bungee cord across top of base column under seat.

It may be necessary to run Tilt Up function to route bungee cord under seat section.

1.Remove four screws from inner shrouds.

2.Lift shrouds, then attach bungee cord hooks under shrouds on both sides.

These illustrations show top components removed for clarity only.

630 Chair Cladding Removal / Installation

1.Insert large, flat blade screwdriver into slot at the front and the back of side cladding and twist to disengage.

2. Unsnap side cladding to remove.

3.Remove two screws from front cladding.

4.Remove one screw from back cladding.

1.Position rear cladding and secure with one screw.

2.Position front cladding and secure with two screws.

3.Position side cladding and snap into place.

Equipment Alert

Lower the base before removing the shrouds. This illustration shows the base raised and top components removed for clarity only.

For ease of shroud removal, it is recommended to remove the bail. This illustration shows top components removed for clarity only.

630 Chair Shroud Removal / Installation

1.Remove two screws and two bushings.

2.Slide bail forward and remove.

Equipment Alert

Be sure front bail tabs capture the column top tabs.

1.Position bail on top of column.

2.Secure with two bushings and two screws.

1.Lower base completely, then raise four to six inches.

2. Remove screws from both ends of outer shrouds.

3. Pull shrouds outward to disengage tabs.

4.Repeat for middle and inner shrouds.

5. Remove two screws from inner shrouds.

Be sure shroud tabs stack on top of each other.

1.Position inner shrouds and secure with two screws.

2.Position middle and outer shrouds and secure with screws at both ends.