QuickClean™ Ultrasonic Cleaners Base Plate Assembly Access Procedures
To prevent risk of shock always disconnect power before removing covers or performing any service procedure.
Table Top Unit
1.Turn power off, unplug, and drain water from tank and place the front (display side) of ultrasonic down on a soft cloth to prevent damage to the display.
2.Remove the four rubber feet (each corner) and screw(s) from bottom of the ultrasonic. Number of screws depends on model.
3.Separate bottom plate from ultrasonic and rotate top of plate down and away from unit. This allows you to place the bottom plate on the table with out disconnecting wires.
Recessed Unit
1.Place front (plug/power switch) side of unit down and remove the screws from bottom plate. Number of screws depends on model.
2.Separate bottom plate from ultrasonic and rotate top of plate down and away from unit. This allows you to place the bottom plate on the table without disconnecting wires.
